My 1600SW power supply has recently stopped working. Where can I
get a replacement?
The Flat Panel Display uses a 12V, 3.33A 40W power brick. It is
possible to use a power supply other than those supplied by SGI
as long as the voltages match and you can find a suitable connector.
An RS 329-3047 (www.rswww.com)
12V 40W switched mode PSU should work. Also visit www.ultraflexinc.com
to purchase a replacement for your 1600SW.
Alternatively, you can use the power supply from the MLA if you
are using one. It uses the same brick but less power, so you can
wire the MLA and the 1600SW in parallel.
Is it possible to run dual
1600SW displays?
There has been a reported setup of two 1600SW displays being hooked
up to twin Oxygen VX1-1600SW PCI cards under Windows 2000.
Alternatively, to use newer graphics accelerators you could use
a combination of AGP/PCI cards with *two* MLAs driving dual displays.
It is also possible to use a single AGP graphics accelerator with
dual DVI ports. However, the card must be able to output 1600 x
1024 @ 60Hz (SuperWide) on both ports. The nVidia-based Gainward
graphics card has dual DVI ports and can output 1600SW-savvy resolutions
on *both* ports. The shareware application PowerStrip can
also be used to create customized settings.
Visit www.realtimesoft.com
and download the utility UltraMon if you are planning on using multiple
monitors under W2000/XP.
There is a flat panel display
that looks identical to the 1600SW. What is this?
In 1999 Miro Displays released the same 1600SW display repackaged
as the Radius Artica. Sporting a translucent Blue and White styling
to match the then new range of Apple G3s, the Radius Artica was
originally shipped with a Number 9 Revolution IV-FP (Windows) or
Formac ProFormance 3 graphics accelerator (Mac). To see what the
display looks like click here.
How can I adjust the 1600SW's
brightness/contrast?
The utility HawkEye (W9x/NT) allows you to do just that. Unfortunately,
the utility is not available for Linux (or W2000 for that matter!)
However, there is a workaround if you are using a dual-boot system
which includes a W9x/NT setup.
Any adjustments made to the 1600SW's contrast/brightness are saved
to the display. Therefore, you could make any adjustments in W9x/NT
and then reboot with the OS of choice. The monitor will remember
the settings.